 |
Outdoor Matting Agent M60
Matting agent M60 for polyester/TGIC powder coatings
It is suitable for polyester/TGIC system with gloss above 15 degrees. According to the quality of TGIC,
every 15-20 parts of M60 consumes one part of TGIC, with little smoke in milling and baking, excellent
yellowing resistance and delicate and plump surface.
1)Typical Properties:
Gloss range:15%above @60°;
Be used in powder coatings based on polyester/TGIC; React with TGIC by 1:20; Super anti-yellowing; Good weatherability;
Few fumes during the stoving process.
2) Incorporation and Processing Instructions
The product should be mixed with the resin, hardener, pigments, and other additives using a high-speed mixer and extruded along with all components. Product Description
3)Recommended Levels
1-4.5%additive (as supplied)based on the total formulation when extruding with all formulation components. More dosage for lower gloss. The above-recommended levels can be used for orientation.
Optimal levels are determined through a series of laboratory tests.
Notes:
An appropriate amount of filler can improve the matting effect, which would influence the leveling.
An appropriate amount of accelerator can improve the impact resistance, which would influence the gloss and leveling.
| Material Safety Data Sheet |  M60-Chinese MSDS pdf | M60-English MSDS pdf |
| Technical Data Sheet | M60-Chinese TDS pdf |  M60-TDS English. pdf |
Outdoor Matting Agent M60
Matting agent M60 for polyester/TGIC powder coatings
It is suitable for polyester/TGIC system with gloss above 15 degrees. According to the quality of TGIC,
every 15-20 parts of M60 consumes one part of TGIC, with little smoke in milling and baking, excellent
yellowing resistance and delicate and plump surface.
1)Typical Properties:
Gloss range:15%above @60°;
Be used in powder coatings based on polyester/TGIC; React with TGIC by 1:20; Super anti-yellowing; Good weatherability;
Few fumes during the stoving process.
2) Incorporation and Processing Instructions
The product should be mixed with the resin, hardener, pigments, and other additives using a high-speed mixer and extruded along with all components. Product Description
3)Recommended Levels
1-4.5%additive (as supplied)based on the total formulation when extruding with all formulation components. More dosage for lower gloss. The above-recommended levels can be used for orientation.
Optimal levels are determined through a series of laboratory tests.
Notes:
An appropriate amount of filler can improve the matting effect, which would influence the leveling.
An appropriate amount of accelerator can improve the impact resistance, which would influence the gloss and leveling.
| Material Safety Data Sheet |  M60-Chinese MSDS pdf | M60-English MSDS pdf |
| Technical Data Sheet | M60-Chinese TDS pdf | M60-TDS English. pdf |