 |
Commercial Curing Accelerator KC5280
KC5280 can be used as a curing accelerator for pure epoxy, epoxy/polyester and polyester/TGIC systems, which can reduce the curing temperature of the system, shorten the curing time, improve the incomplete curing of the system, improve the impact strength of the plate surface, and enhance the adhesion of the substrate.
1)Typical Properties:
Loaded with polyester；
Humidity resistant;
Impact resistant;
Superb thermal stability;
Anti-yellowing;
Enhance adhesion of the base material;
Lower the curing temperature;
Shorten the curing time;
Accelerate ring opening polymerization;
Lower the curing temperature.
2)Recommended Use
KC5280 is used in powder coatings based on polyester/TGIC, pure epoxy and polyester/epoxy.
3)Special Features and Benefits
Curing the polyester and powder coatings.
Cost performance: Catalyze the curing reaction with low dosage.
4)Recommended Levels
0.05-0.1 % additive (as supplied) based on the total formulation when extruding with all formulation components.
The above-recommended levels can be used for orientation.
Optimal levels are determined through a series of laboratory tests.
| Material Safety Data Sheet : |  KC5280-Chinese.pdf |  KC5280-Englsih.pdf |
| Technical Data Sheet : |  KC5280-Chinese.pdf | KC5280-English.pdf |
Commercial Curing Accelerator KC5280
KC5280 can be used as a curing accelerator for pure epoxy, epoxy/polyester and polyester/TGIC systems, which can reduce the curing temperature of the system, shorten the curing time, improve the incomplete curing of the system, improve the impact strength of the plate surface, and enhance the adhesion of the substrate.
1)Typical Properties:
Loaded with polyester；
Humidity resistant;
Impact resistant;
Superb thermal stability;
Anti-yellowing;
Enhance adhesion of the base material;
Lower the curing temperature;
Shorten the curing time;
Accelerate ring opening polymerization;
Lower the curing temperature.
2)Recommended Use
KC5280 is used in powder coatings based on polyester/TGIC, pure epoxy and polyester/epoxy.
3)Special Features and Benefits
Curing the polyester and powder coatings.
Cost performance: Catalyze the curing reaction with low dosage.
4)Recommended Levels
0.05-0.1 % additive (as supplied) based on the total formulation when extruding with all formulation components.
The above-recommended levels can be used for orientation.
Optimal levels are determined through a series of laboratory tests.
| Material Safety Data Sheet : | KC5280-Chinese.pdf | KC5280-Englsih.pdf |
| Technical Data Sheet : | KC5280-Chinese.pdf | KC5280-English.pdf |